EXTREME-DUTYAIR COMPRESSORSLS580V-601LS7580V-601LS580V-501LS7580V-501LS580V-603LS7580V-603LS580V-503LS7580V-503INSTALLATION AND OPERATION MANUALSHIP
10DRAIN AIR TANK DAILY. Water will condense in the air tank. If not drained, the water will corrode and weaken the air tank, causing a risk of air tan
11AIR FILTERNever run the compressor pump without an intake air filter nor with a clogged intake air filter(s). Use compressed air to blow the filters
131645 Lemonwood Dr.Santa Paula, CA. 93060, USATel: 1-805-933-9970Toll Free: 1-800-253-2363Fax: 1-805-933-9160www.bendpak.comLIMITED WARRANTY1. DURAT
14MAINTENANCE / INSPECTION RECORDS____________________________________________________________________________________________________________________
15This page intentionally left blank.
For Parts or Service Contact:BendPak Inc. / Ranger Products, 1645 Lemonwood Dr.Santa Paula, CA. 93060 Tel: 1-805-933-9970Toll Free: 1-800-253-23
2This page intentionally left blank.
3DESCRIPTIONAir compressor units are intended to provide compressed air to power pneumatic tools, operate spray guns and supply air for pneumatic
4GENERAL SAFETYSince the air compressor and other components (material pump, spray guns, filters, lubricators, hoses, etc.) may be under high pressure
5SPRAYING PRECAUTIONS1. Fast moving air will stir up dust and debris which may be harmful. Release air slowly when draining moisture or depressurizing
INSTALLING A SHUT-OFF VALVEA shut-off valve should be installed on the discharge port of the tank to control the air flow out of the tank. The valve s
7Recommended wire sizes may be larger than the minimum set up by local ordinances. If so, the larger size wire should be used to prevent excessive lin
8LUBRICATIONTHIS UNIT CONTAINS NO OIL. Before operating compressor. Fill to the center of the sight gauge or maximum mark on dipstick. Some residual
9BREAK-IN PROCEDURESThis procedure is required before the air compressor is put into service, before the hose is installed, the check valve is replace
Comments to this Manuals