Ranger Products R7580V-603 Specifications download pdf (Page 11)

AIR FILTER

Never run the compressor pump without an intake air filter

nor with a clogged intake air filter(s). Use compressed air

to blow the filters clean. Do not wash or oil the element. If it

cannot be blown clean, the filter(s) must be replaced.

Operating compressor with a dirty filter can cause high oil

consumption and increase oil contamination in the discharge

air.

INTERCOOLER TUBING

Intercooler fins are very sharp. Always wear gloves and use

care when you clean or work near the intercooler

tubing. Weekly, check the intercooler to be sure all fittings

are secure and tight. Blow all dirt, dust and other

accumulations from the intercooler fins.

COMPONENTS

Turn off all power and use light air pressure to blow dust and

foreign material from cylinder head, motor, fan blades, air

lines, intercooler and tank on a monthly basis.

When using an air blow gun always wear

eye protection and face mask/respira-

tor. Fast moving air will stir up dust and

debris which may be harmful.

BELTS

The v-belt(s) should be adjusted so that a declination of

about 3/8 – 1/2 inch will be obtained when it is pushed by a

finger at the middle point as shown.

Over tightening the v-belt(s) will result in overloading of the

motor and belt failure, while a loose belt will be slipping

and resulting in an unstable speed, overheating the belt

and high amp draw. To change tension, loosen the motor

hold-down bolts and slide the motor on the base, using a

lever if necessary, or by turning the adjusting bolt at the end

of the base. Retighten motor hold-down bolts. NOTE: Do

not over tighten belts.

Also, align belts using a straight edge against the face of the

flywheel and touching the rim on both sides of the face. The

belts should be parallel to this straight edge. Dimension A

should be the same as B and C to ensure proper alignment

of the belts. Slots in the bed-plate allow for sliding the motor

back and forth to adjust belt tension.

TROUBLESHOOTING

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Ranger Products R7580V-603 Specifications Page 11